Catalogue 2026–2027
Programs
20 programs
Air Conditioning Installation & Maintenance (Split AC)
Hands-on installation, commissioning, and maintenance of residential and light-commercial split air conditioning systems covering all major brands and refrigerant types.
VRF/VRV Central Air Conditioning Systems
Design, installation, and commissioning of Variable Refrigerant Flow multi-split systems for commercial buildings, including BMS/centralised control integration.
Refrigeration & Cold Room Technology
Commercial refrigeration systems, cold room panel construction, condensing unit and evaporator installation, and refrigeration fault diagnosis for food storage and processing applications.
HVAC Design & Load Calculation
Systematic HVAC cooling and heating load calculation, equipment selection, duct system design, and design report production for residential and commercial buildings.
Ventilation & Indoor Air Quality Systems
Mechanical ventilation system design and installation, indoor air quality monitoring, energy recovery ventilation (ERV/HRV), and commercial kitchen and bathroom exhaust applications.
Plumbing & Sanitary Installation
Residential and commercial plumbing covering hot and cold water distribution, drainage and vent systems, sanitary ware installation, booster pump systems, and commissioning.
Fire Suppression & Sprinkler Systems
Design, installation, and testing of wet pipe, dry pipe, and pre-action automatic sprinkler systems, and introduction to gaseous suppression systems in line with NFPA 13 and local fire codes.
Water Treatment & Purification Technology
Water quality parameters, filtration, reverse osmosis, UV sterilisation, chlorination systems, and borehole water treatment for residential, community, and industrial applications in Cameroon.
Pump Systems & Water Distribution
Centrifugal and submersible pump selection, installation, pipe sizing for water distribution systems, variable speed drive configuration, and pump maintenance and fault diagnosis.
Gas Installation (LPG & Natural Gas)
Safe installation, testing, and commissioning of LPG and natural gas supply systems for domestic and light-commercial applications in accordance with gas safety regulations.
Automotive Mechanics — Engine & Drivetrain
Comprehensive practical training in petrol and diesel engine diagnosis, overhaul, and repair including fuel systems, timing, gearbox, driveshaft, differential, and brake systems.
Auto Electricals & Diagnostic Systems
Vehicle electrical systems including battery and charging diagnosis, wiring diagram interpretation, OBD2 scanning, ECU sensor testing, and systematic vehicle electrical fault diagnosis.
Electric Vehicle (EV) Technology & Maintenance
Electric vehicle drivetrain architecture, high-voltage battery systems, BMS, electric motors, regenerative braking, and AC/DC charging infrastructure with emphasis on HV safety.
Welding & Metal Fabrication (MIG/TIG/ARC)
Practical welding and fabrication covering SMAW (arc), GMAW (MIG), and GTAW (TIG) welding processes, weld symbol reading, distortion control, and structural steel fabrication project work.
CNC Machining & Metal Turning (Lathe)
Manual lathe operation, CNC milling and turning G-code programming, cutting tool selection, machining parameters, tolerances, and component quality inspection for precision engineering.
Heavy Equipment Operation & Maintenance
Safe operation and daily maintenance of heavy construction equipment including excavators, motor graders, and wheel loaders on a supervised training ground.
Elevator & Escalator Installation & Maintenance
Traction and hydraulic elevator systems, escalator principles, mechanical and electrical component installation, safety device testing, and routine preventive maintenance procedures.
Industrial Pump & Compressor Maintenance
Maintenance and fault diagnosis of centrifugal, reciprocating, and screw pumps and compressors including shaft alignment, mechanical seal replacement, and predictive maintenance techniques.
3D Printing & Rapid Prototyping
FDM, SLA, and SLS additive manufacturing technologies, slicing software setup, design for additive manufacturing (DfAM) principles, and post-processing techniques for engineering applications.
Motorcycle Repair & Maintenance
Practical training in 2-stroke and 4-stroke motorcycle engine servicing and repair, electrical system diagnosis, carburetor/EFI maintenance, and chassis and brake systems.